美国球阀厂家说明-65.pdf

Instruction Manual 377 Trip Valve D200319X012 July 2018  Disconnect any operating lines providing air pressure, electric power, or a control signal to the actuator. Be sure the actuator cannot suddenly open or close the valve.  Use bypass valves or completely shut off the process to isolate the valve from process pressure. Relieve process pressure from both sides of the valve. Drain the process media from both sides of the valve.  Vent the power actuator loading pressure and relieve any actuator spring precompression.  Use lock‐out procedures to be sure that the above measures stay in effect while you work on the equipment.  Check with your process or safety engineer for any additional measures that must be taken to protect against process media. Periodic Operational Check WARNING The following procedure requires taking the trip valve out of service. To avoid personal injury and property damage by uncontrolled process medium, provide some temporary means of control of the process medium while the trip valve is out of service. 1. Isolate the actuator/valve assembly from the process loop. 2. Provide a means of monitoring the supply pressure input to the trip valve. 3. Starting with normal supply pressure applied to the trip valve, slowly reduce the supply pressure until the trip valve trips. The trip valve should trip at the pressure set during the calibration procedures. 4. Increase the supply pressure until the trip valve resets. This should occur at a supply pressure 12.5 to 33 percent above the trip point. 5. If the trip valve fails to trip and reset at the calibrated settings, refer to the calibration procedures. 6. If the trip valve will not calibrate, continue with the following maintenance