VACON 面板操作指南5214110D21_en_-.1_1[1].pdf

VACON Inverter Parameters setting EMB_501 upgrade parameter setting for 0.4m/s for Escalator and Autowalk If there is region or area sets 0.4m/s as the nominal speed of escalator / autowalk, parameters of VACON inverter must be adjusted accordingly. 1: Through operation panel on inverter For NXL type: The picture above is the operation panel on inverter of NXL type. © 2010 KONE Corporation 5214110D21 All rights reserved. 1 (8) VACON Inverter Parameters setting EMB_501 upgrade parameter setting for 0.4m/s for Escalator and Autowalk After the inverter is power on, the default display of operation panel is like below: Then press the button on operation panel, the display of operation panel will be like below: Then press the button on operation panel, the display of operation panel will be like below: Then press the button on operation panel, the display of operation panel will be like below: P2.1.1 is the first parameter in the parameter list, when the display on operation panel is like above, please press button on operation panel until the display is P2.1.21, this parameter is Pre Speed 2, the default value of this parameter is 50.00Hz. Then press button on operation panel, the display of operation panel now is 50.00Hz. Then press button on operation panel, the 50.00Hz will be flashing all the time; at this time, please press button on operation panel until the display is 40.00Hz, flashing all the time. Then press button on operation panel to finish the value setting; at this time, the display of operation panel is 40.00Hz without flashing. So far, the parameter is setting done. © 2010 KONE Corporation 5214110D21 All rights reserved. 2 (8) VACON Inv