分析讲稿202106学习icem prism.pptx

Workshop 5.1 Prism Meshing – Waterjacket Section;Change Working Directory;Geometry Repair Geometry Build Diagnostic Topology Accept default Tolerance 0.1 Filter points = on Filter curves = on Feature angle = 30 (default) Filtering curves and points works well with tetra octree to filter unnecessary constraints at low angles between surfaces Click Apply;Set Mesh Sizes for Tetra Meshing;Tetra Mesh;Check Errors and Quality;Check Surface Mesh for Extrusion;Save Input Mesh;Set Prism Global Parameters;Define Prism Parts and Compute;Inspect Pyramids;Set Local Heights Smaller;Use the quick icon to load the previous tetra mesh (You don’t want to run prism on the mesh that already has prism elements) Choose tet.uns, Open Choose Replace for Mesh Already Exists Compute the prism mesh again Mesh Compute Mesh Prism Mesh Compute;Inspect the Mesh;Smooth;Splits all prisms if no Prism Volume Parts selected Total height remains fixed. Number of layers is being set. That leaves only ratio or initial height as variables. One of them is specified. Specifying a prism ratio or initial height is only practical if there is 1 fat layer to split No point in distributing each split layer independently We will redistribute afterward anyway;Redistribute Prism Nodes;Save mesh and geometry using the quick icons Mesh size parameters are saved to the geometry All the mesh setup parameters for prism are saved to a .prism_params file within the working directory at the time prism is run