RS Components 电工电料 安全继电器 2981745 使用说明.pdfVIP

PSR-SCP- 24DC/URD3/4X1/2X2/3 PSR-SPP- 24DC/URD3/4X1/2X2/3 Safety Relay as a Contact Extension Block With Off-Delay Contacts INTERFACE Data Sheet 102862_04_en © PHOENIX CONTACT - 09/2007 Description Features – Contact extension block The PSR-...- 24DC/URD3/4X1/2X2/3 safety relay can be used as a contact extension block in safety circuits – Safety category 3 according to EN 954-1 according to DIN EN 60204-1/VDE 0113-1. – Plug-in screw or spring-cage connection terminal blocks The device has an interface for the T-BUS DIN rail connector. This interface can be used for single-channel – Single-channel wiring control and monitoring. Alternatively, the device can also be – Safe isolation operated in single-channel mode via a contact on the basic – Housing width 22.5 mm device. – Four enable contacts, one alarm contact, and one Depending on the external wiring, up to safety category 3 confirmation contact according to EN 954-1 can be achieved. The relay has four enabling current paths, one signaling current path, and one confirmation path. Depending on the time set, the contacts drop with a 0.3 ... 3 second delay according to stop category 1 (DIN EN 60204-1/VDE 0113-1). The extension unit can be used as a contact multiplier for emergency stop relays and two-hand controls. Observe the safety instructions on page 4. Make sure you always use the latest documentation. It can be downloaded at . A conversion table is available on the Internet at /general/7000_en_00.pdf. This data sheet is valid for all products l