INVT英威腾-DA200伺服驱动器电子凸轮光标捕获使用说明英文版_V1.0 (1).pdf

ECAM Cursor function 1.Parameter Description P7.80：Cursor Capture Enable After the setting is valid, the ECAM function is automatically enabled by the cursor signal (0x3A) (effective mode: parameter valid) P7.81：Offset Of The Cursor To Cutter The distance from the cursor sensor to the cutter (must be set in a cut length) P7.82：Cursor Sensor Window The cursor signal within the window range around the cursor sensor offset is considered valid. P7.83：Max. Numbers Of Lost Cursor When the number of lost cursors reaches the set value, Ecam is turned off, and when set to 0, the function is invalid. P7.84：Cursor Compensation Method Mode 0: Cut the length after detecting the cursor; Mode 1: Cut the cursor after detecting the cursor. 2.Debugging step (1) Confirm that the fixed length is cut accurately; (2) Confirm that the spindle pulse direction is positive; When the ECAM spindle source is pulse input: When the ECAM spindle source is the second encoder: (3) Confirm that the parameter settings are accurate; When the rising edge of the cursor is detected, if P7.02 is set to parameter valid, ECAM will be automatically enabled. If P7.08 is set to engaged immediately, ECAM will immediately engage for benchmarking. (4) Homing; Confirm that the home sensor is 180 degrees fromthe cutting point; Homing result: (5) Virtual spindle test; You can use the virtual spindle for the simulation test, it has no external interference and does not need to be real cut. P7.03 can select ECAM Spindle Source. Inthe Flying Curve or Shear Curve, Feeding speed (P7.44) will be calculated and written to P7.07. You can set P8.96 to 0x3A: Cursor Signal and monitor this Parameter in software scope, It characterizes the cursor signal. You can also monitor R1.00: Digtial input state. If you want to ensure the follow-up of the sync area, you can set P2.10 to 100.0% Unable test： Enable test： (6) Test the cutting accuracy after the material is