类似工艺流程开发文件1.pptxVIP

;产品工程协作开发团队Product Development Team (PDT);产品工程协作开发模式;;PDT Big 4;SOR中有关模具要求;11.0 Tooling模具 The tooling for key component (for example, fascia, grille, etc) must use SGM approved toolshop, and the manifold supplier for these tooling must be approved by SGM too. The toolshop for other component should inform and agreed by SGM. All other requirements not list here see Appendix O 关键零件(如:蒙皮,进气格栅…) 的模具必须用通过SGM/GM批准的模具供应商, 而且这些模具的热流道供应商也必须用通过SGM批准。 其他零件的模具供应商应该告知SGM且经SGM同意。 所有此处未列出的其他需求见附录O.;11.2 Moldflow Analysis 模流分析 Supplier is responsible for Modlflow analysis on PATAC