catia caa二次开发详细教程8草图上创建几何图形.pdfVIP

CATIA CAA 二次开发 详细教程（8）草图上创建几何图形 在上一节的基础上，开始创建草图。首先创建草图工厂： CATI2DWFFactory_var sketch2DFactory(spSketch); 下面创建点： CATI2DPoint_var spPt_bottom_left, spPt_bottom_right, spPt_top_right, spPt_top_left; double pt_bottom_left[2] = {10., 10.}; double pt_bottom_right[2] = {50., 10.}; double pt_top_right[2] = {50., 50.}; double pt_top_left[2] = {10., 50.}; spPt_bottom_left = sketch2DFactory->CreatePoint(pt_bottom_left); spPt_bottom_right = sketch2DFactory->CreatePoint(pt_bottom_right); spPt_top_right = sketch2DFactory->CreatePoint(pt_top_right); spPt_top_left = sketch2DFactory->CreatePoint(pt_top_left); 开始创建线： CATI2DLine_var spLine1, spLine2, spLine3, spLine4; spLine1 = sketch2DFactory- >CreateLine(pt_bottom_left,pt_bottom_right); spLine2 = sketch2DFactory->CreateLine(pt_bottom_right,pt_top_right); spLine3 = sketch2DFactory->CreateLine(pt_top_right,pt_top_left); spLine4 = sketch2DFactory->CreateLine(pt_top_left,pt_bottom_left); 将线连接起来： CATI2DCurve_var spCurve1 (spLine1); CATI2DCurve_var spCurve2 (spLine2); CATI2DCurve_var spCurve3 (spLine3); CATI2DCurve_var spCurve4 (spLine4); spCurve1->SetStartPoint(spPt_bottom_left); spCurve1->SetEndPoint(spPt_bottom_right); spCurve2->SetStartPoint(spPt_bottom_right); spCurve2->SetEndPoint(spPt_top_right); spCurve3->SetStartPoint(spPt_top_right); spCurve3->SetEndPoint(spPt_top_left); spCurve4->SetStartPoint(spPt_top_left); spCurve4->SetEndPoint(spPt_bottom_left); 然后退出草图： spSketch->CloseEdition();