EBSILON® 电站锅炉建模.pdfVIP

® Ebsilon Professional Training Modelling of Boiler 锅炉建模 Dr. Hans-Peter Wolf Boiler-components No. 88, 89, 90, 91 锅炉组件88 ，89 ，90 ，91 Motivation for the development of detailled Boiler components 研发详细的锅炉组件的动机 • Previously modelling of boiler using existing heat-exchanger components • 以前是用现存的换热器组件来模拟锅炉 • There was no possibility to calculate the heat transfer depending on geometrical data • 因此不能根据几何尺寸来计算热传递 • The existing heat-exchanger components were sufficient for heat-recovery steamgenerators, but not for coal-fired boilers where heat-transfer by radiation dominates heat-transfer by convection in certain zones of the boiler • 现存的换热器组件用来模拟余热锅炉已经足够，但不适用于以辐射传热为主导，且 某些区域又有对流换热的煤粉炉。 • The new components allow the detailled modelling of heat transfer by radiation by configuring the geometrical data (dimensions of pipes, walls, etc.) • 这些新的组件允许通过调节几何尺寸数据详细地模拟辐射热传递（定义管道、管壁 等的尺寸） May 2017 Training Boiler 2 Boiler components No. 88, 89, 90, 91 Modelling strategy 建模策略 • Separate Modelling of fluegas side and water/steam side • 分开模拟烟气侧和汽水侧 • Separation of fluegas side into 3 zones : • 烟气侧分为3个区域： • Reaction zone: Combustion, ash removal, radiation • 反应区：燃烧器，除灰，辐射 • Radiation zone: heat transfer dominated by radiation, no reaction • 辐射区：以辐射为主导的热传递，无反应 • Convection zone: heat transfer dominated by convection (tube bundles), no reaction • 对流区：以对流换热为主导（管束），无反应 • Fluegas components describe the fluegas zones in which the heat-transfer surfaces are located • 烟气组件描述了烟气区中受热面的布局位置 • Modelling of supporting pipes or membran walls as auxiliary heating surfaces if tube bundle is already existen