READ CAREFULLY BEFORE USING YOUR DOLPHIN DIAGNOSTIC 2001 3001 ROBOT POOL CLEANER说明书用户手册.PDF

READ CAREFULLY BEFORE USING YOUR DOLPHIN DIAGNOSTIC 2001 / 3001 ROBOT POOL CLEANER I N S T A L L AT I O N The power supply [#1] [with or without the CADDY] should be positioned so that the DOLPHIN can reach all the walls of the swimming pool and must be at a minimum distance of 3 meters [10 Ft.] from the edge of the pool [Fig. a]. Factory-wired for either 100V, 115V or 230V mains supply, the voltage rating should be checked before connection. Ensure that the mains/line outlet is protected by a ground fault interruptor [GFI] or earth leakage interruptor [ELI]. Use only the original DOLPHIN power supply. The DOLPHIN pool cleaner and power supply have been designed for safe, maintenance- free outdoor use. D O L P H I N C A D D Y Your DOLPHIN CADDY is factory-assembled, except for the wheel assembly and the handle. A S S E M B L Y A N D When assembling, please follow these instructions and refer to the diagram. Insert the O P E R A T I N G wheel assembly [c-1] firmly into the groove at the bottom of the base ensuring it is I N S T R U C T I O N S centered with a plastic washer [c-2] on each side. Insert the two straight pieces of pipe [c-3] into the holes in the tower [c-4] until they clip onto wishbone clips in the studs at the base of the tower. Fit the two hooks [c-5] to the top of the pipes until they clip into the wishbone clips in the pipes. Fit the top of the handle [c-6] until it clips onto the wishbone clips [c-7] in the hooks.