惠普HP 零售书店彩扩打印机系列HP Photosmart ML1000 Minilab Printer - Cleaning drum screen job aid.pdf

Minilab Printer ML1000 Cleaning drum screen Clean drum screen daily at closing. Note: If minilab prints more than 2000 prints each day, clean drum screen up to twice daily. Note: If dark spots appear on back side of prints, clean drum screen. Note: If minilab is in Sleep mode, press On/Off button and wait for minilab to come to Ready state as shown on touchscreen. 1 Prepare cleaning material. 2 Open front doors. For cleaning, HP recommends using HP Equipment Cleaning Wipes, but you can use an HP-approved lint-free wipe and deionized or distilled water. 3 Lower print carriage 4 Unlock locking plates. locking bar.  2 1. Lift locking plate tabs. 2. Rotate plates toward you to unlock. Rev. 08.07.09 © 2009 Hewlett-Packard Development Company, L.P.  of 4 PN CC680-90003 HP Photosmart ML1000 JOB AID Minilab Printer ML1000 Cleaning drum screen 5 Pull out print carriage. 6 Attach electrostatic discharge (ESD) strap. Grip print carriage by upper corners. 1. Put on ESD strap according to Pull forward about 6 inches. manufacturer’s instructions. Caution: Do not touch printheads or 2. Insert ESD plug into jack behind damage can result. carriage front cover. 7 Clean drum screen. 8 Orient drum. 1. Wipe back and forth across entire 1. Rotate drum so IDC is on top