日本电波法附表9标准测试方法.pdfVIP

Revision of the Ministerial Ordinance for Determining Technical Standards for Electrical Appliances (Lithium Ion Secondary Batteries) Attached Table 9 Lithium ion secondary batteries 1. Basic design (1) Insulation and wiring a) The insulation resistance between the positive terminal and a metal surface (excluding electrical contact surfaces and electrical parts having the same potential as the electrode potential of the battery) exposed to outside the battery, and which, as mounted on the equipment, may be touched by a human, shall be 5 MΩ or more at 500 VDC. b) Internal wiring and its insulation shall sufficiently withstand anticipated maximum current, maximum voltage, and maximum temperature. c) Equipment having connection terminals shall be wired to maintain an appropriate clearance and creepage distance between terminals. (2) Inner pressure reduction mechanism a) Battery cases and cells shall be designed with a gas release mechanism, or shall be designed to reduce excessive internal pressure when the equipment reaches a value or rate set so as to protect against explosion or fire. b) If support material is used to fix cells within the battery case, the type of support material and method of fixing cells shall not inhibit pressure relief, and the battery shall not induce overheating during normal use of the battery. (3) Temperature or and current management The battery shall be designed so that abnormal temperature-rise conditions are prevented. Provided that this does not apply if a current limiter is installed outside the battery to control abnormal temperature-rise during charging and discharging within a safety level. (4) Terminal contacts a) The battery shall be marked positive (+) or negative (-) for terminals on its external surface or be designed with no fear of misconnection. b) Batteries having a terminal contact plate shall be sized and shaped to ensure the