EMERSON艾默生 Instruction Manual P341 and P342 Manual Latches and P389 and P631 Pneumatic Actuators Fisher说明书用户手册.pdf

Instruction Manual Types P341, P342 and P389 MCK-0397 September 2015 Types P341 and P342 Manual latches and Type P389 Pneumatic actuator Introduction ! WarnIng Failure to follow these instructions or to properly install and maintain this equipment could result in an explosion and/or fi re causing property damage and personal injury or death. Fisher® equipment must be installed, operated and maintained in accordance with federal, state and local codes and manufacturer’s instructions. The installation in most States must P1140 also comply with nFPa no. 58 and Figure 1. Type P341 Latch/Remote Release Mechanism anSI K61.1 standards. Only personnel trained in the proper procedures, codes, standards and regulations of the lP-gas industry should install and service this equipment. Scope of the Manual This manual covers instructions for installing the Types P341 and P342 manual latches and P1109 Type P389 pneumatic actuator for the Type C407-10 Figure 2. Type P389 Pneumatic Cylinder internal valve. • Type P341—Latch/remote release mechanism that built-in fusible element will release at 212°F / 100°C permits remote valve closure. The valve is opened manually. A built-in fusible element will release and allow the valve to close. Factory type number at 212°F / 100°C and allow the valve to close. for the Type P342 installed is Type C407MB10. Factory type number for the Type P341 installed is • Type P389—Pneumatic cylinder that allows remote Type C407M10. opening and closing of the valve. • Type P342—Latch/bi-d