ABB PowerMark Plus Load Centers Installation Instruction for 100-225A Single and Three-Phase 10-42 Circuit 说明(英语)用户手册.pdf

1 GEH5021 - Installation Instructions PowerMark Plus™ Load Centers 100–225 Ampere Single and Three Phase 10–42 Circuit Indoor Type WARNING: Hazard of electrical shock or burn. Turn 4. Remove Knockouts for All Main and Branch Circuits off power before working inside this equipment. General To comply with the National Electrical Code and Underwriters Laboratories, the load center must be installed in accordance with the information included on the label on the inside of the door. 1. Remove Front Slip the front and accessory package back into the carton to First knock the center knockout inward. The outer rings should be alternately pried up or driven in one at a time. protect the finish. 5. Pull Incoming Service and Branch Circuit Wiring into Box 2. Remove Interior (optional) 6. Replace Interior Drive in the mounting screws loosened in step 2. 7. Wire Main, Neutral, and Equipment Ground Refer to the rating label inside the equipment for the proper tightening torque. Mounting Bond Screw Screws Hole Back out mounting screws and save for use. 3. Moun