各向同性的板Homogenous【翻译】.pdfVIP

第一章 各向同性的板Homogenous 同质的 On the Homogenous tab, you define a thickness for a single panel. 在“同质”选项卡上，可以为单个面板定义厚度。 Specify homogeneous thickness parameters: 指定均匀厚度参数： Label - In this field, specify the label (name) of the defined thickness type. 标签-在此字段中，指定定义厚度类型的标签（名称）。 Color - In this field, select the color for the defined thickness type. 颜色-在此字段中，为定义的厚度类型选择颜色。 Thickness 厚度 Constant - When you select this option, the thickness of the surface structure element will be constant. 常量-选择此选项时，曲面结构元素的厚度将保持恒定。 Th field - In this field, type the thickness value for a surface structure element (panel), when a constant thickness was selected along the entire finite element (panel). Th字段-在该字段中，键入沿整个有限元（panel ）选择恒定厚度时曲面结构元素（panel ）的厚度值。 Variable along a line - When you select this option, the thickness of the defined surface element (panel) of the structure will be linearly changing. You will be required to define the thickness of the panel at two points (P1 and P2). 沿直线变化-选择此选项时，结构的已定义表面元素（面板）的厚度将线性变化。您需要在两点（P1和 P2）定义面板的厚度。 Variable on a plane - When you select this option, the thickness of the defined surface element of the structure (panel) will be changing according to the defined plane. You will be required to define the thickness of the panel at three points (P1, P2, and P3), which define the panel thickness change plane. 平面上的变量-选择此选项时，结构（面板）的已定义表面元素的厚度将根据定义的平面发生变化。您需 要在三个点（P1、P2和P3）定义面板的厚度，这三个点定义面板厚度更改平面。 Reduction of the moment of inertia - when this is selected, it allows reduction of elements of the bending inertia matrix. 转动惯量减小-选择此选项后，可减少弯曲惯量矩阵的元素。 Reduction has no effect on the membrane stiffness (compression, tension) and transversal forces. Elements of the bending matrix for finite elements are multiplied by a specified value of the reduction factor. 减薄对薄膜刚度（压缩、拉伸）和横向力没有影响。有限元弯曲矩阵的元素乘以折减系数的指定值。 Reduction of moments of inertia for RC sections is applied in static calculations to account for the influence of section cracks. This