YAMAHA BC2 说明书用户手册.pdf

GD Headset This allows you to wear the breath controljer on your head, like headphones, @ Mouthpiece Blow into this part. The mouthpiece can also be washed after removing it from the pipe (pulling it of. 于 the drain cap @ is used at the end of the mouthpiece pipe, you can alter the amotnt of breath necessary to control the data, from a iittle to a lot. 加 Pipe Since the pipe moves freely, you can move it to the position where the mouthpiece can most easily be used. However, take care with it, as 让 may break 让 bent too far or too often, Q@Connecting This plugs into the Breath Controller terminal of the synthesizer or MIDI keyboard. Plug @ Offset screw This screw controls the data value that is output when you are not blowing into the controller. Turn the screw clockwise for ahigherouput. @ Gain screw This screw controls how sensitive the unit is to your breath. Turn the screw clockwise for a higher sensitivity (a larger change in the Gata， with less breathy). 人 Screwdriver This Screwdriver can be used to adjust the offset screw and the gain screw. 图 Drain cap This cap changes the size of the outiet at the end of the pipe in the mouthpiece section. This allows you to adjust the amount of air that passes through. If it is pushed in as far as possible, no air will pass through. 让