三菱 M800SM80E80 Series Connection and Setup 控制器用户手册 EN.pdfVIP

Introduction This manual covers the items required for installing, connecting and setting up the Mitsubishi Electric CNC. Supported models are as follows: Supported models Abbreviations in this manual M800S Series M850S, M830S M80 Series M80 TypeA, M80 TypeB E80 Series E80 TypeA, E80 TypeB Abbreviations in this manual are as follows: Abbreviations Supported models M800, M800 Series M800S Series M80, M80 Series M80 Series M800/M80, M800/M80 Series M800S Series/M80 Series M8, M8 Series M800S Series/M80 Series/E80 Series Read this manual thoroughly and understand the products functions and performance before starting to use. This manual is written on the assumption that all optional functions are added, but the actually delivered device may not have all functions. The unit names, cable names and various specifications are subject to change without notice. Please confirm these before placing an order. Be sure to keep this manual always at hand. This manual notes a reference chapter as Chapter: Section: Paragraph. (Example) For 4.1.1 Environment Conditions inside the Control Panel : General Specifications: Environment Conditions: Environment Conditions inside the Operation (4.1.1 Environment Conditions inside the Operation included in 4.1 Environment Conditions of 4 General Specifications) Notes on Reading This Manual (1) This book is configured as follows. Refer to the following chapters as necessary. Installation and connection: Chapter 1 to 15 Setup: Chapter 16 to 36 (2)