Street Smart Security CEREMDW Door Sensor User Manual 03 CEREMDW Manual 090403说明书用户手册.pdf

Door Sensor (door sensor magnet separately on door/ window and door/ window frame) CEREMDW User Manual Place CEREMDW door sensor magnet separately on door/ window and door/ window frame. A signal will be sent to control. If door/ window is open which will be detected by CEREMDW. User will be alerted if the door/ window is open. The Door sensor is designed for your full protection including switch. It gives you all angles of protection you can even think of. PRODUCT SPECIFICATION Operating Frequency: 433.92MHz+-150KHz Operating Temperature: -20 to 60 C (-4 to 140 F) Battery: 3VDC Panasonic CR2032 Lithium battery * 2pcs Battery Life: 2 years (under normal usage) Dimensions (W*H*D): 35.76*57.58*15.20mm Build-in Detector: Tamper, Back, Reed Switch Type of Modulation: ASK BATTERY REPLACEMENT Remove the cover by pressing on the end notch to lift top cover. Unscrew the screw on the PCB and remove the PCB. Use care when installing the battery and observe the correct polarity. Use ONLY the CR2032 lithium battery. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] this device may not cause harmful interference and [2] this device must accept any interference received, including interference that may cause undesired operation. S/N ： Made in Taiwan