Peavey百威 DPM 3SE and DPM 3V EPROM Insertion Instructions用户手册说明书.pdf

KG DPMe 3SE DPMS V3 EPROM Insertion Instructions NOTE: THIS PRODUCT SHOULD BE INSTALLED ONLY BY AN AUTHORIZED DEALER OR AUTHORIZED SERVICE CENTER TD ENSURE PRESERVATION OF WARRANTY. H will be necessary to change the Operating System Scftware inside the DPMe 3 by replacing the existing EPROMS with the new set supplied with the Software Version update. This is done by placing the DPM 3 on a flat, protected working surface and performing the folowing procedure. 1，After Saving 记 Disc all internal application programs, eftfects, sequences, etc., insert and run the diagnostic disc，Execute theAllmem test. This will prepare the unit to boot new software, 2，After successful diagncstic Gompletion, re-initialize the unit. 了 initialize insert mono phone plug into tihe 他” pedal jack. Tirn unit off wait ten seconds, and turn back cn. Press“Muli” button, then press“Pause while holding down“Muti” When the display reads initialize DPM 3 Memory?… release “Muli and “Pause and depress the softkey above Exec” on the display. 3，Turn the unit of, then make sure that the unit is disconnected from the AC mains power and any other squip- ment that is currently used in your system. 4 Remove the two front panel…tie-down screws in the two hidden locations as illustrated below. This is best done with a Phillips-head screwdriver with a magnetized ip io minimize the risk of dropping the Screw inside the unit. WA AAA 大 六 7 和 NN SN 全 DPMr 3 Bottom ViIew Front Panet “TileDown Screws