I-Port投球压裂滑套.pdfVIP

Section 300 / Doc. 104 Product I-Port Frac Sleeve P / N ET1021-45B-000 Revision 13 –APR - 2011 I-Port Frac Sleeve The ET 1021 I-Port Frac Sleeve is designed for use in selective stimulation of multi- zone wells in open hole or cemented completion applications, especially with the T-Frac™ system. It is activated by circulating a ball to a drillable seat inside the tool, when hydraulic pressure is applied from surface the differential pressure created across it shears the inner sleeve piston, moving it downwards to open up the frac ports. The inner sleeve piston is locked in the full open position by a ratchet ring, allowing stimulation of the zone. The I-Port Frac Sleeve can be run in multiple quantities with each having a different ball and seat size with the smallest on bottom and progressively larger sizes moving up the hole. Features and Benefits  Available in sizes 2-7/8”, 3- 1/2” and 4-1/2”.  The internal locking mechanism ensures that the frac ports remain fully open once the sleeve is activated.  The ball seat is drillable resulting in a full bore ID matching the pipe size.  The shear pressure setting is field adj ustable.  Once activated, the ball and seat act as a bridge plug preventing any communication to lower zones.  Available in seat ID ranging from 0.786” to 3.536” accommodating setting ball sizes from 1” to 3.75” in increments of 0.25”.  Can be run in quantities of 5 for 2-7/8’, 6 for 3-1/2” and 12 for 4-1/2”  Available in materials suitable for standard or sour service.