led7分析和总结分析和总结.docxVIP

1. #include RGB_PWM.h 2. 3. CONFIG(0X3F76); 4. uchar MachineState=0; //机器状态 uchar Tcount; uchar Rcount,Gcount,Bcount; //定义占空比的 高电平计数 uchar Tcount; uchar Kcount; //定义存储的比列系数9. 10. static void interrupt USART_RXC_ISR(void) 11. { CLRWDT(); if(TMR1IF) //定时器中断处理 14. { TMR1IF=0; TMR1H=0xFF; //定时时间:500000uS,误差:0uS TMR1L=0xEB; Tcount++; if(Tcount=Rcount) RedDriver=0; if(Tcount=Gcount) GreenDriver=0; if(Tcount=Bcount) BlueDriver=0; if(Tcount=Fcount) 23. { 24. Tcount=0; 25. if(Rcount==0) RedDriver=0; 26. else RedDriver=1; 27. if(Gcount==0) GreenDriver=0; 28. else GreenDriver=1; 29. if(Bcount==0) BlueDriver=0; 30. else BlueDriver=1; 31. } 32. } 33. else PIR1=0; 34. } 35. 36. 37. void main(void) 38. { 39. SystemInit(); LCD_Initialize(); LCD_SendCommand(DISP_ON); LCD_SendCommand(CLR_DISP); LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(..RGB..PWM...); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!...); stateini(); timer1_ini(); CLRWDT(); 51. 52. while(1) 53. { CLRWDT(); if(!SW3) //功能的转换 56. { 57. delay(30,40); 58. if(!SW3) 59. { MachineState++; if(MachineState5) MachineState=1; switch (MachineState) 64. { case 1: LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(..PWM..Red...); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!...); break; case 2: LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(.PWM..Green..); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!...); break; case 3: LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(..PWM..Blue...); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!...); break; case 4: LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(.....Save. ); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!. ); break; case 5: LCD_SendCommand(DD_RAM_ADDR_1); LCD_SendText(.....Read. ); LCD_SendCommand(DD_RAM_ADDR_2); LCD_SendText(....Ready!!!. ); break; default: break; 96. } 97. } 98. }while(!SW3) CLRWDT();; 99. //********************************** 100. if(!SW1) //增量函数处理 101. { uchar tempdata; CLRWDT(); switch (MachineState) 105. { case 1: