Danfoss丹佛斯VLT® 5000 calculation time flying start 应用指南.pdf

Application Note Calculation of Maximum time for flying start The measurement is based on the time constant for the motor T . T can be calculated from R and L for S S S S the motor: T = L / R . (The stray inductively is considered part of L ). S S S S The following table gives TS for the motor with corresponding nominal VLT size: VLT 5001 5002 5003 5004 5005 5006 5008 5011 5016 5022 5027 kWmotor 0,75 1,1 1,5 2,2 3 4 5,5 7,5 11 15 18,5 TS [sec] 0,07 0,10 0,10 0,15 0,12 0,17 0,2 0,26 0,28 0,35 0,45 VLT 5032 5042 5052 5060 5075 5100 5125 5150 5200 5250 kWmotor 22 30 37 45 55 75 90 110 132 160 TS [sec] 0,49 0,64 0,70 0,80 0,74 0,87 1,06 1,53 1,56 1,46 1. First a 10 Hz is sent to the motor in order to determine the RPM direction, and the peak current is measured at the same time. This event takes about 2xTS . 2. Then a magnetising current is adjusted to the right value, at the search frequency. This event also takes about 2xTS . 3. A search for the motor frequency is now started from the max. ref. frequency +10%. Either a course search of 0,1 Hz / per sample or a fine search of 0,025 Hz / per sample is initiated. Each sample time is approximately 0,002 sec. If the peak current as detected under point 1. is high, then the course search is used; but as the search frequency is close to the motor frequency, then the current is lower and the fine search is initiated, this is also the case if