Danfoss丹佛斯Decoupling Plate H3 安装指南.pdf

Installation Instructions Decoupling Plate H3 VLT® Compressor Drive CDS 803 Item Supplied Mounting • Decoupling plate Step 1 Mount metal plate on frequency converter and fasten with 2 Safety screws. Tightening torque: 2 Nm. For important information about safety precautions for instal- lation, refer to VLT® Compressor Drive CDS 803 Quick Guide. WARNING DISCHARGE TIME The frequency converter contains DC-link capacitors, which can remain charged even when the frequency converter is not powered. Failure to wait the specified time after power has been removed before performing service or repair work could result in death or serious injury. 1. Stop compressor. 2. Disconnect AC mains, permanent magnet type Illustration 1.1 Mounting of Metal Plate compressors, and remote DC-link power supplies, including battery back-ups, UPS, and DC-link connections to other frequency converters. Step 2 Mount bracket on decoupling plate. 3. Wait for the capacitors to discharge fully, before performing any service or repair work. The waiting time is specified in Table 1.1. Voltage [V] Cooling capacity [TR] Minimum waiting time (min) 3x200 4-6.5 15 3x400 4-5 4 3x400 6.5 15 Table 1.1 Discharge Time