Danfoss丹佛斯Decoupling Plate H4 and H5 安装指南.pdf

Installation Instructions Decoupling Plate H4 and H5 VLT® Compressor Drive CDS 803 Item Supplied Mounting • Decoupling plate Step 1 Prepare decoupling kit. Safety For important information about safety precautions for instal- lation, refer to VLT® Compressor Drive CDS 803 Quick Guide. WARNING DISCHARGE TIME The frequency converter contains DC-link capacitors, which can remain charged even when the frequency converter is not powered. Failure to wait the specified time after power has been removed before performing service or repair work Illustration 1.1 Preparation could result in death or serious injury. 1. Stop compressor. 2. Disconnect AC mains, permanent magnet type Step 2 compressors, and remote DC-link power supplies, Mount decoupling kit on frequency converter and fasten it including battery back-ups, UPS, and DC-link with 2 screws. connections to other frequency converters. Tightening torque: 2 Nm. 3. Wait for the capacitors to discharge fully, before performing any service or repair work. The waiting time is specified in Table 1.1. Voltage [V] Cooling capacity [TR] Minimum waiting time (min) 3x200 4-6.5 15 3x400 4-5 4 3x400 6.5 15 Table 1.1 Discharge Time Illustration 1.2 Mounting Danfoss A/S © Rev. 09/201