CCNA final2 部分题目分析和总结.docx

3 In which situation would a default static route be recommended? when connecting an edge router to the Internet when variable length subnet masking is in effect when there is more than one valid route for a destination network when a destination network has a larger mask than any routes in the routing table 6 An administrator is configuring Router1 so that it can connect to Router2 by using IP. Which protocol can be used by Router1 to determine the IP address of Router2 when they are directly connected and only Layer 2 connectivity exists between them? ARP CDP ICMP Telnet 7 Refer to the exhibit. The IP addresses on all interfaces on router R1 were configured before the OSPF protocol had been enabled on the router. No OSPF router ID was manually configured. Which IP address will be selected by the router as an OSPF router ID? 10.10.10.1 172.16.1.1 172.16.2.1 192.168.1.1 192.168.100.1 9 Which prompt is used to allow a user to change the IP address of an interface on Router Router# Router(config)# Router(config-if)# 10Which two statements are true for OSPF Hello packets? (Choose two.) They are used for dynamic neighbor discovery. 10 They are used to maintain neighbor relationships. They are used to determine the complete network topology. They are used with timers to elect the designated router with the fastest They are used to negotiate correct parameters among neighboring interface 11 Refer to the exhibit. Host A is unable to access the Internet, and troubleshooting ha that this is due to an addressing problem. What is incorrectly configured in thi the IP address of the Fa0/0 interface of R1 the subnet mask of the S0/0/0 interface of R1 the IP address of the S0/0/0 interface of R1 the subnet mask of the S0/0/0 interface of R2 12 12 Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has bee installed in the network. Which set of commands is required to configure a singl for the networks that R2(config)# router are connected to R2? ospf 1 R