Danfoss丹佛斯RTS2 Combined radiation and room temperature sensor 数据表.pdf

Installation Guide RTS2 Combined radiation and room temperature sensor Danger! This device may only be installed by a qualified electrician in accordance with the circuit diagram in the operating instructions. The existing safety regulations must be observed. Application This sensor was specially developed to record the room and/or radiation temperature in residential, hotel and office rooms under normal ambient conditions. Function There are 4 NTC sensors in the sensor housing, two act as room temperature sensors, the other two are glued directly into the black hemisphere as radiation sensors. This combination allows, for example, when the room is not occupied, the reduced temperature or frost protection to be monitored by the room sensor, and when the room is occupied, the radiant heat can be recorded by the radiation sensor. In the case of combined heating systems, it is possible to regulate the “feel good temperature” which is determined from the room and radiation temperature using a suitable evaluation device Technical specifications Degree of protection: IP30 Ambient temperature: -20 ... +70°C Measurement current: 1mA Ball pressure test : 75°C Pollution Degree: 2 Electrical connection: screw terminals (0.14 ... 1.5 mm2), cable length max. 50 m, (only for use with safety extra low voltage, max. 30V~ / 42V4) Avoid parallel routing with lines carrying mains voltage or use shielded lines. Mounting: Wall mounting or installation on an UP box Colour: pure white, similar to RAL 9010, hemisphere in black. © Danfoss Climate Solutions | 2023.06 AI000086402676en-000101| 1 RTS2 Wiring Diagram TPOne B TPOne M COM NC2 - OFF