Brinno缩时拍TLC200Pro USER MANUAL FIRMWARE UPGRADE PROCEDURE说明书用户手册.pdf

Firmware Time Lapse Camera Upgrade TLC200 Pro Procedure version EN A1 Before doing rmware upgrade process, please follow below steps and unzip the rmware upgrade package. Step 1 Ensure your Time Lapse Camera is powered down and remove SD card from the camera. Then insert the SD card into your computer. Power OFF Step 2 Copy and save the le TLC200PR.BIN into 200TLCPR folder in the SD card (200TLCPR folder DCIM should locate in the DCIM folder) ** If your SD card doesn’t have a folder named 200TLCPR in the 200TLCPR DCIM folder, please create those folders by yourself! TLC200PR.BIN Step 3 Insert the SD card into the Time Lapse Camera. Insert Step 4 Power on the Time Lapse Camera. Power ON Step 5 After the upgrade tool has fully loaded, you will see an Updating Warning message on LCD screen, it means that the camera is updating rmware. Please ! do not power o the camera when you see the warn- ing!! Just wait until the upgrade is completed! DO NOT TURN OFF Done Once completed the upgrade, verify your new ver- sion to make sure the upgrade was successfully com- pleted. Finished ! Please do not TURN OFF power or REMOVE SD card when camera is updating rmware as that will damage the camera! Supports: customerservice@ 2013.09.16