Danfoss丹佛斯Vickers by Danfoss Proportional Valves Proportional Directional Valves KDG3V-3 and KDG3V-5 Series Technical Information 用户指南.pdf

® Technical VICKERS by Danfoss Information Proportional Valves BC459431513105en-000101 Proportional Directional Valves Hydraulic Pilot Operated KDG3V-3 and KDG3V-5 Series ISO 4401-03 and -05 (NFPA D03 and D05) Interfaces 660 Introduction Vickers by Danfoss KDG3V-3 and -5 valves spool. Load pressure acts on the area of are used in open loop hydraulic circuits to the pin and opposes the pilot pressure, direct and meter ow in proportion to thus closing the spool. For a given pilot pilot pressure commands. The pressure, ow decreases as load resulting controlled ow is used to pressure increases, until maximum determine the direction, velocity and pressure is reached at zero ow. acceleration/deceleration of hydraulic Maximum load pressure can be cylinders or motors. changed by changing the pilot pressure. The KDG3V is controlled by applying Pressure, actuator and tank port pilot pressure, through an operator connections are made by mounting the mechanism, to either end of the valve’s valve on a subplate or manifold. Vickers by normally spring-centered spool. The Danfoss hydraulic remote controls (catalog resulting force causes spool travel GB-MC-2032A) are an ideal means of when it is greater than the opposing providing pilot pressure for the KDG3Vs, spring force. and ultimately providing precise low-eort control of actuator functions. Optional pressure feedback models have a small pin inside the ends of the Features and Benets KDG3V valves, manufactured to NFPA fatig