TASCAM达斯冠专业音响CD-RW901MKII说明书用户手册.pdf

CD-RW901) Confirmation of firmware version Before updating the firmware check the CD-RW901MKII system and drive firmware versions used. 1. While pressing both the ESCAPE and m [ g] buttons, (system version) and DRV Ver xx.xx (driver turn the unit on. Keep pressing the buttons until the version) shown here. versions are shown. If the system and drive firmware version shown here is 2. Turn the MULTI JOG dial to select SYS Ver the same or newer than the firmware version that you xx.xx or DRV Ver xx.xx, and press the planned to update to, then there is no need to update MULTI JOG dial. Check the SYS Ver xx.xx it. Procedures to update the system firmware Prepare a blank CD-R or CD-RW disc and a computer or other means to create a data CD. CAUTION Be very careful not to cut the power to the unit during firmware updating. If the power should be interrupted during firmware updating, the unit could become unstartable or otherwise damaged. 1 Download the file 4 Confirmation of firmware version Download the latest firmware from the TEAC Global Follow the “Confirmation of firmware version” Site (/). Uncompress the instructions above to check that the system firmware downloaded file if it is in a ZIP format or otherwise version is now the most recent version of the firmware. compressed. This completes the procedure for updating this unit. 2 Create a data CD for updating the unit Write the downloaded firmware to the disc. (Firmware V1.01 is “RW901M2_0101.MOT”.) Use ISO 9660 Level 1 (MS-DOS compatible) Disc at once f