51单片机芯片资料_常用芯片手册_CD4051B.docxVIP

CD4051B, CD4052B, CD4053B Data sheet acquired from Harris Semiconductor SCHS047C August 1998 - Revised August 1999 CMOS Analog Multiplexers/Demultiplexers with Logic Level Conversion Features ? Wide Range of Digital and Analog Signal Levels - Digital . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3V to 20V The CD4051B, CD4052B, and CD4053B analog multiplexers are digitally-controlled analog switches having low ON impedance and very low OFF leakage current. Control of analog signals up to 20VP-P can be achieved by digital signal amplitudes of 4.5V to 20V (if VDD-VSS = 3V, a - Analog. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ≤20VP-P ? Low ON Resistance, 125? (Typ) Over 15VP-P Signal Input Range for VDD-VEE = 18V ? High OFF Resistance, Channel Leakage of ±100pA (Typ) VDD-VEE of up to 13V can be controlled; for VDD-VEE level differences above 13V, a VDD-VSS of at least 4.5V is required). For example, if VDD = +4.5V, VSS = 0V, and VEE = -13.5V, analog signals from -13.5V to +4.5V can be controlled by digital inputs of 0V to 5V. These multiplexer circuits dissipate extremely low quiescent power over the full VDD-VSS and VDD-VEE supply-voltage ranges, independent of the logic state of the control signals. When a logic “1” is present at the inhibit input terminal, all channels are off. at VDD-VEE = 18V ? Logic-Level Conversion for Digital Addressing Signals of 3V to 20V (VDD-VSS = 3V to 20V) to Switch Analog Signals to 20VP-P (VDD-VEE = 20V) ? Matched Switch Characteristics, rON = 5? (Typ) for VDD-VEE = 15V ? Very Low Quiescent Power Dissipation Under All Digital- Control Input and Supply Conditions, 0.2μW (Typ) at VDD-VSS = VDD-VEE = 10V The CD4051B is a single 8-Channel multiplexer having three binary control inputs, A, B, and C, and an inhibit input. The three binary signals select 1 of 8 channels to be turned on, and connect one of the 8 inputs to the output. ? Binary Address Decoding on Chip ? 5 V, 10V and 15V Parametric Ratings ? 10% T