钢渣细骨料泡沫混凝土的制备及性能.pdfVIP

钢渣细骨料泡沫混凝土的制备及性能.pdf

  1. 1、本文档共6页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
Vol. 40 No. 2 安徽工业大学学报(自然科学版) 第40卷第2期 April 2023 J. of Anhui University of Technology (Natural Science) 2023年4月 文章编号:1671-7872(2023)02-0213-06 钢渣细骨料泡沫混凝土的制备及性 浩,项国圣,李华健 (安徽工业大学建筑工程学院,安徽马鞍山243032) 摘要:以钢渣作为细骨料,采用不同粒径、取代量的钢渣制备钢渣泡沫混凝土 (SSFC)O根据自然养护7 d SSFC的无侧限抗压 强度,得出制备SSFC的最优配比;基于正交试验分析钢渣粒径、钢渣取代量、水胶比三因素对SSFC抗压强度的影响程度;在 此基础上,探讨钢渣取代量对SSFC导热性、抗折强度、吸水率等力学性能的影响,分析不同钢渣取代量下SSFC的微观结构。 结果表明:制备SSFC的最优配比为钢渣粒径1.18 mm、钢渣取代量(质量分数,下同)20%、水胶比0.45;三因素对SSFC抗压 强度的影响程度为钢渣取代量〉钢渣粒径〉水胶比;随钢渣取代量的增加,SSFC的导热性和吸水率逐渐减小、抗折强度先增后 减,钢渣取代量为20%时SSFC抗折强度最大,这是因为20%钢渣取代量下的SSFC平均孔径最小、孔隙分布最均匀。 关键词:泡沫混凝土;最优配合比;抗压强度;钢渣;水胶比 中图分类号:TU 528.2 文献标志码:A doi: 10.12415/j.issn.l671-7872.22072 Preparation and Properties of Steel Slag Fine Aggregate Foamed Concrete WANG Hao, XIANG Guosheng, LI Huajian (School of Civil Engineering, Anhui University of Technology, Maanshan 243032, China) Abstract: Steel slag was used as fine aggregate, and steel slag foam concrete (SSFC) was prepared by using steel slag with different particle size and replacement amount. According to the unconfined compressive strength of SSFC naturally cured for 7 d, the optimal mix proportion was obtained. Based on the orthogonal test, the influence of steel slag particle size, steel slag substitution and water-cement ratio on the compressive strength of SSFC was analyzed. On this basis, the influence of steel slag substitution on the mechanical properties of SSFC such as thermal conductivity, flexural strength and water absorption was explored, and the microstructure of SSFC under different steel slag substitution was analyzed. The results show that the optimal proportion for preparing SSFC is 1.18 mm steel slag particle size, 20% steel slag replacement (mass fraction, the same below), and 0.4

您可能关注的文档

文档评论(0)

经典文库 + 关注
实名认证
服务提供商

人力资源管理师持证人

专注于各类文档、文案、文稿的写作、修改、润色和各领域PPT文档的制作,收集有海量各类规范类文件。欢迎咨询!

领域认证该用户于2025年05月14日上传了人力资源管理师

1亿VIP精品文档

相关文档