morph8弹簧圈半径第5章域句柄练习更改在本中您将增加.pdfVIP

Chapter 5: s and Handles Exercise: Changing the Radius of the Spring Coil In thi ercise, you will rease the radius of the spring coil. Figure 1: Before and after morphing Step 1: Load and review the model. Open the HyperMesh file, spring.hm. Step 2: Change the coil radius. 1. Access the s create sub-panel in one of the following ways: • On the Morphing , select Create, then select s • On the Tool page, select HyperMorph, then s 2. Switch type to 2D s. 3. Verify that the elements toggle is set to all elements. 4. Verify that only the partition 2D s option is active. 5. Click create. HyperWorks 10.0 HyperMorph Introduction 35 Proprietary Information of Altair Engineering, . Chapter 5: s and Handles 6. Go to the morph alter dimensions sub-panel in one of the following ways: • From the Morphing , select Morph, then the alter dimensions sub-panel. • On the Tool page go to HyperMorph, then select morph, then alter dimensions 7. Change the morphing method to radius. 8. Change the center calculation to by axis. 9. Change the axis to the z-axis. Figure 2: s and base node to select for altering the coil radius 10. For s (under edge and 2D) select the 2-D and the two edge s. 11. For the base node for the z-axis select the node as shown in Figure 2. 12. Keep the default settings for the remaining options. 13. Activate add to current. 14. In the radius field, type 20. 15. Click morph. Summary Twenty units are added to the coil radius. HyperMorph Introduction 36