ABB PM Gold Riser Panel Installation Instructions - 125A 1PH 12-24ckt - DEH-40005 手册(英语)说明书.pdf

DEH40005 Installation Instructions For 125 g Ampere Single Phase 12-24 Circuit PowerMark Gold TM Riser Panel Indoor Type WARNING: Hazard of electrical shock or burn. Turn off power supplying this equipment before 4. REMOVE KO’S FOR ALL MAIN AND working inside. BRANCH CIRCUITS. General To Comply with the National Electrical Code and Underwriters Laboratories, the load center must be installed in accordance with the information included on the label on the inside of the equipment. This must also be done in accordance with applicable local electrical codes, and by a qualified Knockout Center KO electrical contractor and/or licensed electrician. inward then Outer Rings 1. REMOVE FRONT First knock center KO inward. Outer rings should be Remove screws from cover, save for reuse. alternately pried up or driven in one at a time. 5. PULL INCOMING SERVICE AND 2. REMOVE INTERIOR. (Optional) BRANCH CIRCUIT WIRING INTO BOX. 6. REPLACE INTERIOR Drive mounting screws from Step 2. CAUTION Back Out