基于电磁仿真软件的平面变压器共模电磁干扰建模方法及其应用.pdfVIP

2020 年 12 月 电 工 技 术 学 报 Vol.35 No. 24 第 35 卷第24 期 TRANSACTIONS OF CHINA ELECTROTECHNICAL SOCIETY Dec. 2020 DOI: 10.19595/ki.1000-6753.tces.191368 基于电磁仿真软件的平面变压器共模 电磁干扰建模方法及其应用 高 璐 徐 策 董光冬 龚春英 张方华 （南京航空航天大学自动化学院 南京 211106 ） 摘要 传统的变压器模型多为集总电容模型，在 10MHz 以上的频段，模型与实测特性存在 较大偏差，难以反映变压器的高频电磁干扰（EMI ）特性。该文提出利用S21 参数来衡量变压器 共模EMI 性能，研究平面变压器高频3D 建模方法。通过实际测试验证了3D 建模方法的准确性， 并将该建模方法应用于某高频变压器的共模EMI 性能评估及优化设计中，从制造工艺水平和材料 特性参数等方面，分析影响变压器共模S21 参数一致性的关键因素，为提高产品性能的一致性提 供了质量管控依据。 关键词：变压器3D 模型 共模EMI CST 软件 敏感性分析 中图分类号：TM15 Common Mode Electro-Magnetic Interference Modeling Method of Planar Transformers Based on CST Software and Its Application Gao Lu Xu Ce Dong Guangdong Gong Chunying Zhang Fanghua （College of Automation Engineering Nanjing University of Aeronautics and Astronautics Nanjing 211106 China ） Abstract The traditional transformer model is mostly a lumped capacitance model. There is a large deviation between the frequency model characteristics and the actual measurement above 10MHz. It is difficult to reflect the high-frequency electro-magnetic interference (EMI) characteristics of the transformer. In this paper, the S21 parameter was used to measure the common mode EMI performance of transformers. The high-frequency 3D modeling method of planar transformer was studied. The accuracy of the 3D modeling method was verified by actual tests. The modeling method was applied to the common mode EMI performance evaluation and optimization design of a high-frequency transformer. From the aspects of manufacturing process level and mater