ANALOG DEVICES An ADuC824-Based Temperature-Logger 说明书用户手册.pdf

ANALOG MicroConvertere Technical Note - UC015 DEVICES An ADuC824-Based 和 INTRODUCTION: The battery-powered temperature logger in Figure 1 was built to demonstrate some features of the ADuC824 MicroConverter.， This document briefly describes what the unit does and how to use 计 WHATIT DOES: In short, it logs a precise temperature reading every 10 minutes, storing the last 23 hours of temperature readings for upload to a PC，The temperature reading comes from a precision RTD connected directly to the ADC front-end of the ADuC824 (note that no external signal conditioning circuitry is needed). Software running on the ADuC824 applies a linearization routine to the RTDs transfer function, and then stores results in on-chip non-volatile Flash/EE data memory until they can be uploaded to a PC.，In this “logging mode”of operation，the ADuC824 enters powerdown mode between conversions， thereby minimizing logging mode average current consumption allowing for Figure 1: extended battery life. The Temp Logger PCB The unit enters a second mode of operation (display mode) when you press the momentary pushbutton，、In display mode, the ADuC824 performs a temperature measurement every half- second and displays the result on the LCD. It also sends each result out the UART as serial data that can be streamed to a PC，Even in display mode, the temp logger continues to log a reading every 10 minutes, thereby continuing the logging function uninterrupted. PIH24 Temperature Demo Board RereE 二 加 于 HOW TO USE IT: 三” tings Hep ANAL 站 To use the temperature logger for displaying jumpers are inserted (ie. J2 is open) and ) ) | | )} 器 这 酸 real-time temperature，simply make sure no insert batteries (two CR2032 type)，or just