RockwellAutomation罗克韦尔800HL Potentiometer用户手册说明书.pdf

INSTALLATIONINSTRUCTIONS 800HL-EMP POTENTIOMETER FOR NEMA TYPE 7 [3/8 (9.5) TO 2-1/2 (50.8) PANELS] ANDTYPE9[7432(7.2) TO 2-1/2{50.8) PANELS] 大 WARNIN To avoid damageto equipment orinjuryto personnel, electrical power must be off before and during installation and maintenance. Maintain 估 (12.7)minimumclearancethroughairbetween current-carrying parts and enclosure. ADJUSTNG NUT SETSCREWS ADAPTERRING PANEL HOUSING 171601.6) HEX WRENCH 区 TIGHTEN TO4 172LBHN SECURINGRNG 一 站 MOUNTING RNG MOUNTING UsHING 一 Room LEGEND PLATE Figure1 Installations see Figure 1 forillustrated assembly 1. Placesecuringringand/oradjustingnutassuppliedonunitandthreadunit into paneluntil pushing extends approximately 11/32 (8.7) [4to 5threads], Pastfront of panel- 9/32 (7.1) [3 to 4threadsjifalegend plateis notto be used, see Figure 3. 2 Tosecure unit rotate toa position which provides electrical clearance and tighten adjusting nutand/orlocking screw Wheretwo unitsare mounted adjacently arrange securing rings to avoid interference、 3 Whenlnstallinginametalenclosure, maintain 172 (012.7)minimum -earancethrough air between cunentcarying partsendlosure. 4，Place legend plate ifto be used over mounting bushing 5。Assemble mounting ring adapter and tighten. 6，Rotate shaft counterclockwise to stop。 7，Position kneb on shaft aligning white indexer on knob with minincrement marking on legend plate. 8、Tighten the two set screws in the knobto 4 土 扩 上 b.-in.