ISO TR 15608-2005焊接 金属材料分类体系指南.docxVIP

TECHNICAL ISO/TR REPORT 15608 Second edition 2005-10-15 Welding — Guidelines for a metallic materials grouping system Soudage — Lignes directrices pour un systame de groupomant dos materiaux metaliques Rofcrence nurber ISO/IR 156082005(1) ◎ISO 2005 ISO/TR 15608:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed bu shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The iso Central Secretariar accepts no liabiity in this area Adobe is a trademark of Adobe Systems Incorporated Details of the software products used to create this PDF file can be found in the General info relative to the filc; the PDF creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodics.In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utiized in any torm or by any means, clectronic or mechanical, including photocopying and microfitm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56·CH- 1211 Geneva 20 Tel.+41227490111 Fax +41227490947E-mail Fax +41227490947 Web Published in Switzerland ii ◎ISO 2005·All rights reserved ISO/TR 15608:2005(E) Contents Page Foreword iv Introduction v 1 Scope 1 2 Grouping system for steels 1 3 Grouping system for aluminium