斗式提升机维护检修规程.pdfVIP

斗式提升机维护检修规程

二○○七

目录

1总则························································································································6·77

2完好标准···············································································································6·77

3斗式提升机的维护及常见故障···········································································6·78

3.1维护···········································································································6·78

3.2常见故障及处理方法···············································································6·79

4斗式提升机的检修·······························································································6·79

4.1检修周期及内容·······················································································6·79

4.2检修方法及质量标准···············································································6·81

5试车与验收·········································································································6·84

6维护检修安全注意事项·························································································6·85

６７６

1总则

1.1适用范围

参照原化学工业部颁发的《斗式提升机维护检修规程》(HG25038－91)以及其他有关

资料，编制本规程。

本规程适用于水煤气站的PL－350型斗式提升机(以下简称为“提升机”)的维护与检修。

提升机的附属设备如减速机等的维护检修按有关规程执行。

本规程与制造厂的有关技术文件相抵触时，应遵循制造厂的有关技术文件的规定。

1.2结构简述

PL－350型斗式提升机由头尾传动组件、牵引构件、机壳、进出料溜槽等部件组成。

牵引构件上的料斗，由电动机经减速器间接驱动，在电机同减速机之间的联轴器处装有止

逆装置以防止斗式提升机倒转。

PL－350型斗式提升机用于将振动筛筛下粒度小于25mm的焦炭(或无烟煤)提升后输送

到螺旋输送机，并由螺旋输送机送至焦粉贮槽。

水煤气站所用PL－350型斗式提升机主要技术性能如下：

结构特性采用板式套筒滚子链条作牵引构件；

卸载特性连续布置料斗，慢速重力卸载；

输送物料焦粉(煤粉)；工作温度常温；