自带动力式联合整地机机架有限元仿真分析.pdfVIP

圆园25年第6期新疆农机化窑开发研究窑

文章编号院1007-7782渊2025冤06-0023-05

自带动力式联合整地机机架有限元仿真分析

12111

刘思杰，荆建峰，李继霞，王泽晖，马尚鹏

（1.克拉玛依职业技术学院，新疆克拉玛依834000；2.克拉玛依市独山子区晟通热力有限责任公司，新疆克拉玛依833600）

摘要院为验证自带动力式联合整地机机架结构设计的可靠性与合理性，本文基于ANSYS有限元分析软件，对机架

开展静力学与预应力模态分析。首先明确整机结构组成及工作原理，随后通过网格划分、载荷与约束设置，构建机架

有限元模型并进行静力学求解，同时在静力学分析基础上完成1~6阶预应力模态分析。静力学结果显示，机架最大

应力为96.26MPa，远低于材料屈服强度，最大变形为1.087mm，满足强度与刚度要求；模态分析表明，机架前6阶固

有频率为22.383~49.694Hz，完全避开了作业时88~112Hz的激振频率的共振区间。研究结果为该类型机架的后续优

化设计提供了理论参考。

关键词院联合整地机；机架；有限元仿真

Finiteelementsimulationanalysisoftheframeofaself-

propelledcombinedtillagemachine

LiuSijie,JingJianfeng,LiJixia,WangZehui,MaShangpeng12111

(1.KaramayVocationalandTechnicalCollege,Karamay834000,Xinjiang,China;2.ShengtongHeatingCo.,Ltd.,DushanziDistrict,

Karamay833600,Xinjiang,China)

Abstract:Toverifythereliabilityandrationalityoftheframestructuredesignforaself-propelledcombinedtillagemachine,this

studyconductedstaticandprestressedmodalanalysisoftheframeusingANSYSfiniteelementanalysissoftware.First,theoverall

structuralcompositionandworkingprincipleswereclarified.Subsequently,theframefiniteelementmodelwasconstructedand

solvedstaticallythroughmeshing,loadandconstraintsettings.Basedonthestaticanalysis,prestressedmodalanalysisforthefirstsix

orderswascompleted.Thestaticanalysisresultsindicatethatthemaximumstressintheframeis96.26MPa,whichissignificantly

belowtheyieldstrengthofthematerial.Themaximumdeformationis1.087mm,meetingtherequirementsforstrengthand

stiffness.Themodalanalysisindicatesthatthefirstsixnaturalfrequenciesoftheframerangefrom22.383to49.694Hz,completely

avoidingtheresonancerangeof88to112Hzduringoperation.Theresearchfindingsprovidethe