模具设计论文.doc

目 录 摘要····································································Ⅲ ABSTRACT····························································Ⅳ 1 前 言 1.1 课题的特点及研究意义·················································1 1.2 模具发展行业的研究现状················································1 1.3 课题设计思路及研究内容···············································2 2 工艺分析及计算 2.1 引言··································································3 2.2 冲压件工艺分析························································3 2.3 冲压件工艺方案的确定··················································3 2.4 冲压件工艺计算························································4 2.4.1 修边余量的确定·····················································4 2.4.2计算毛坯直径························································4 2.4.3 排样及搭边·························································7 2.4.4 拉深次数的确定·····················································7 2.4.5 拉深凹模圆角的确定·················································8 3 模具设计 3.1 落料拉深模具设计······················································9 3.1.1 落料拉深凸凹模结构的确定及有关尺寸的计算···························9 3.1.2 落料凹模结构的确定················································10 3.1.3 拉深凸模结构的确定及有关尺寸的计算································11 3.1.4 拉深凹模结构形式的选择············································12 3.1.5 其他零件的选择····················································13 3.1.6 闭合高度的计算····················································14 3.1.7 冲裁力的计算及压力机的选择········································15 3.1.8 模具总装图························································18 3.2 二次拉伸模具设计·····················································19 3.2.1 拉深凸模和凹模结构的确定及有关尺寸的计算··························19 3.2.2 确定是否使用压边圈················································20 3.2.3 其他零件的选择····················································20 3.2.4 闭合高度的计算····················································22 3.2.5 拉深力的计算及压力机的选择········································22 3.2.6 模具总装图·······································