【精品】毕业设计：双出头秸秆液压成型机的设计.doc

PAGE  PAGE 22 河南科技学院 2009届本科毕业论文（设计） 论文题目：双出头秸秆液压成型机的设计 学生姓名：张松飞 所在院系：机电学院 所学专业：机电技术教育 导师姓名：马孝琴 完成时间：2009年5月26日 摘 要 我国农作物秸秆资源非常丰富，但大部分没有得到合理有效的利用。生物质能源转换技术在使秸秆资源得到充分利用的同时，也增加了农民的收入，为促进农业的可持续发展做出贡献。 本论文是通过对HPB-III生物质成型机出现的各种问题进行理论分析，并在此基础上做出改进设计，设计出一种新型成型机(双出头秸秆液压成型机)。这种成型机以液压驱动、双向成型为基础，从产业化的角度对HPB-III型生物质成型机进行了液压系统和成型部件的改进设计，采用双缸双活塞双阀，使该成型机运行压力在8 MPa左右，低压运行，稳定性提高，综合性能提高，生产率达到500kg/h，单位能耗70kWh/t左右，进一步推动了生物质固化成型技术的发展。 关键词:生物质(秸秆)，液压成型机，液压成型，改进设计 The Design of Bi- Direction Biomass Briquetting Machine by Hydraulic Driven ABSTRACT Crop residues are very abundant in our country. but most of them haven’t got sufficient use. Biomass energy converting technology make the full use of straw resource become possible, on the same time, it also increase the income of farmer, and pay attribute to the improvement of the agricultural sustainable development. This paper used theory analysis to analyze all kind problems of HPB-III, used improved design, designed a new briquetting machine (THE BI-DIRECTION BIOMASS (STRAW) BRIQUETTING MACHINE BY HYDRAULIC DRIVEN). Based on the fluid power drive and bi-direction briquetting, the hydraulic system and the HPB-III briquetting machine components were improved on design. Two-cylinder, double-valve, and double-piston technology has been used. After operation test, it showed that the operation pressure has dropped, the stability has enhanced and the overall performance has improved. The productivity achieves 500kg/h, unit energy consumption reaches to 70kWh/t, and the operation pressure was about 8 MPa, basically solved the technical promotion problems of the briquetting machine. Key words: Biomass (Straw), Briquetting machine by hydraulic piston, Hydraulic press, Improved design 目 录  INDEX \o S \c 2 \z 2052   TOC \o 1-3 \h \z \u  HYPERLINK ../../../../../../DOCUME~1/ADMINI~1/LOCALS~1/Temp/Rar$DI04.250/000打印 zsf双出头秸秆液压成型机的设计.doc \l _Toc231145779#_Toc2311457791 绪论  PAGEREF _Toc231145779 \h 1  HYPERLINK ../../../../../.