毕业设计--细长轴类零件车削夹具设计.docVIP

郑州科技学院 专 科 毕 业 设 计 题 目 细长轴类零件车削夹具设计 学生姓名 张辰浩 专业班级 机械制造与自动化2班 学 号 200724132 所 在 系 机械工程系 指导老师 邬宝寅 完成时间 2010.3.2 细长轴类零件车削夹具设计 摘 要 机械加工精度是加工质量的重要组成部分。分析加工精度对保证加工质量、提高生产率和降低成本都有重要意义。 细长轴指长度与直径之比大于20的轴。细长轴类零件刚性差,车削时由于切削力、切削热所引起的线膨胀、轴自重、工艺系统刚性等因素很容易引起轴弯曲变形、振动,不易获得满意的加工精度。machine-center design The reasons that the machine cut precision affected by machine tool and that of machine tool,work piece and cutter by cutting for and cutting heating were analyzed in the clinder machine cut process.The principal of machine precision for slim shaft work piece was summarized. A reasonable improving proposal was put forward as well. Abstract view of the current more common C6163 Machine Tool Center frame for design, right through to the finished product observation and analysis, and the actual operational experience, measurement, Special design of such centers-production drawings. Because I was limited, and it is inevitable that the article had weaknesses and deficiencies and hopes readers criticized corrected. Keywords : Slender Shaft Center frame Turning 目 录 摘要………………………………………………………………………………3 ABSTRACT……………………………………………………………………4 1 引言 …………………………………………………………………………5 1.1 机械制造业的发展势 …………………………………………………6 1.2 健康绿色的制业……………………………………………………… 8 2 课题来源‥…………………………………………………13 2.1 课题来源………………………………………………………………13 3 设计介绍…………………………………………………………………14 3.1 细长轴的定义…………………………………………………………14 3.2 夹具主要技术参数分析………………………………………………14 4 材料选用……………………………………………………………………15 4.1材料的选用 ……………………………………………………………15 5 中心架总成 ………………………………………………………15 5.1中心架总成 ……………………………………………………………15 6 主要零件图及部件组织注意点…………………………………16 7 热处理工艺………………………………………………………………18 7.1 预备热处理………………………………………………………………18 7.2 最终热处理………………………………………………………………19 致 辞 ………………………………………………………………………21