基于51单片机的16路抢答器.docVIP

? ? ? ?最近学习51单片机，偶尔有些想法，随手写了些程序。下面是实现16路抢答器功能的C语言代码。绝对原创，欢迎各位参考，引用请注明出处。由于各种开发板布线不尽相同，各位可以根据实际情况，稍加修改即可。 ? ? ? ?作者：唐全延 #includereg52.h #define uchar unsigned char #define uint unsigned int sbit b=P3^2; uchar key,num,num2=10,num1=11; uchar code table[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90}; void scankeys(); void display(); void delay(uchar); void de(uchar); void main() { TMOD=0x11; TH0=(65536-50000)/256; TL0=(65536-50000)%256; EA=1; ET0=1; TR0=1; if(num2==10) { b=0; delay(10); b=1; } while(1) { if(key!=0|num2==0) { b=0; delay(100); b=1; TR0=0; while(1) { display(); } } scankeys(); display(); } } void t0() interrupt 1 { TH0=(65536-50000)/256; TL0=(65536-50000)%256; num++; if(num==20) { num=0; num1--; if(num1==0) num1=11; } } void delay(uint a) { uint i,j; for(i=a;i0;i--) for(j=120;j0;j--); } void de(uchar c) { uchar k,l; for(k=c;k0;k--) for(l=88;l0;l--); } void display() { uchar b0,b1,b6,b7; num2=num1-1; b0=key%10; b1=key/10; b6=num2%10; b7=num2/10; P0=table[b6]; P1=6; delay(1); P0=table[b7]; P1=7; delay(1); P0=table[b1]; P1=1; delay(1); P0=table[b0]; P1=0; delay(1); } void scankeys() { uchar temp; P2=0xfe; de(1); temp=P2; if(temp!=0xfe) { switch(temp) { case 0x7e: key=1; break; case 0xbe: key=2; break; case 0xde: key=3; break; case 0xee: key=4; break; } } P2=0xfd; de(1); temp=P2; if(temp!=0xfd) { switch(temp) { case 0x7d: key=5; break; case 0xbd: key=6; break; case 0xdd: key=7; break; case 0xed: key=8; break; } } P2=0xfb; de(1); temp=P2; if(temp!=0xfb) { temp=P2; switch(temp) { case 0x7b: key=9; break; case 0xbb: key=10; break; case 0xdb: key=11; break; case 0xeb: key=12; break; } } P2=0xf7; de(1); temp=P2; if(temp!=0xf7) { t