[矿物加工专业毕业设计]大杨庄铁矿年处理40万吨选矿厂设计.doc

大杨庄选矿厂年处理量为40万吨原矿，给矿粒度为500～0mm，选厂设计为一次性平地建厂。 大杨庄铁矿属于中硬度矿石，含泥量小，采用三段一闭路破碎流程；主要有用矿物是磁铁矿，且粒度不均匀，细粒选别粒度为0.2mm，采用阶段磨矿，阶段磁选工艺。原矿品位为29.07%。矿石经第一段磨矿分级溢流进入第一段磁选，磁选产品品位为45.8%，产率为55.62%，回收率为89.92%；粗选产品再经过地二段磁选，产品品位为49.50%，回收率为218.98%，产率为128.60%；此时大量的尾矿被甩出，然后第二段磁选产品再进入第二段磨矿，之后对细粒磁铁矿进行选别；磨矿产品经过细筛选别，筛下产品品位为52.79%，产率为48.60%，回收率为88.26%；筛下产品经过第三段磁选，磁选产品品位为64.00%，回收率为85.84%，产率为38.99%；第三段磁选产品再经第四段磁选，精矿品位可达68.00%，回收率为85%，产率为36.34%，精矿经过滤机过滤，含水率小于10%。 关键词：选矿 磁选 精矿品位 阶段选别 Abstract The capacity of the Dayangzhuang dressing plant is 400,000t/a,the plant is going to be built on the ground which is filt and is put up at one time. The Dayangzhuang iron ore is the medium degree of hardness and contains little slime, so we choose the three section of closed crushing circults; Consideration of the mainly valuable mineral is magnetite and the size of magnetite particles are not average ,we adopted stage grinding and magnetic separation technology. The grade of run-of-mine ore is29.07%. The overflow product of the first classifier is given into the first magnetic and the degree of the product of the first magnetic separator is 45.8%, product ratio is 55.62% and recovery of concentrate is 89.92%; Then the concentrate is given into the magnetic separator and the degree,the product ratio and the recovery of concentrate of its are 49.50%,218.98%,128.60% respectively;Now,large aquantity of gangue is separated,then product of the second magnetic separator is given into the second mill ,entering into the stage of separating fine magnetite particles.The product of mill is given into the fine screen and the product of fine screen′s degree, product ratio and recovery are 52.79%,48.60%,88.26% respectively;then the product of the fine screen is given into the third magnetic separator and the degree,the product ratio and the recovery of concentrate of the third magnetic separator are 64.00%,85.84%,38.99% respectively;after that the product pass through the fourth magnetic separator and the concentrate′