51程序合集 包括流水灯按键蜂鸣器继电器译码器数码管点阵pwm步进电机.docVIP

* /*按键则点亮LED灯，8路指示灯接p0口 * #include reg51.h //51的端口和各特殊寄存器定义在此文件中 此包含比不可少 sbit LED = P2^0; //定义LED在P2.0脚上 sbit K1 = P0^0; //定义按钮在P0.0脚上 /*********************************************************/ main() { if(!K1) LED = 0; //当按键按下对应单片机脚变低电平 LED变低灯亮 else LED = 1; //当松开键按对应单片机脚变高电平 LED变高灯灭 } /*按键则点亮LED灯，8路指示灯接p0口 #include reg51.h #include intrins.h sbit BEEP = P1^5; sbit RELAY = P1^4; sbit K1 = P0^0; sbit K2 = P0^1; sbit K3 = P0^2; sbit K4 = P0^3; sbit K5 = P0^4; sbit K6 = P0^5; void beep(); main() { while(1) { P2 = 0xff; if(K1==0) P2 = 0xfe; if(K2 == 0) P2 = 0xfd; if(!K3) P2 = 0xfb; if(!K4) P2 = 0xf7; if (!K5 ) beep(); //喇叭发声 RELAY = 1; if (!K6 ) RELAY = 0; //通过了反相器 } } void beep() { unsigned char i , j; for (i=0;i100;i++) { BEEP=!BEEP; //BEEP取反 for (j = 0 ; j250 ; j++) //需要产生方波 _nop_(); } BEEP=1; //关闭蜂鸣器 } * * 连续按动按钮LED会不停的左移或右移 #include reg51.h #include intrins.h unsigned char scan_key(); void proc_key(unsigned char key_v); void delayms(unsigned char ms); sbit K1 = P0^0; //对应按钮K1 sbit K2 = P0^1; //对应按钮K2 main() { unsigned char key_s,key_v; key_v = 0x03; P2 = 0xfe; while(1) { key_s = scan_key(); if(key_s != key_v) { delayms(10); key_s = scan_key(); if(key_s != key_v) { key_v = key_s; proc_key(key_v); } } } } unsigned char scan_key() { unsigned char key_s; key_s = 0x00; key_s |= K2; key_s = 1; key_s |= K1; return key_s; } void proc_key(unsigned char key_v) { if((key_v 0x01) == 0) { P2 = _cror_(P2,1); } else if((key_v 0x02) == 0) { P2 = _crol_(P2, 1); } } void delayms(unsigned char ms) // 延时子程序 { unsigned char i; while(ms--) { for(i = 0; i 120; i++); } } #include reg51.h //51的端口和各特殊寄存器定义在此文件中 此包含比不可少 main() { if(!K1) BEEP = 0;