美国海宝_精细等离子切割机_HPR130_系统安装手册_中文版.pptVIP

HPR130 Installation Training Point out that this is a water injected machine. Poorer cut quality on mild steel than dry plasma Allows high amperage cutting with N2 Generally considered a non-ferrous machine Maximum O2 amperage is 340A. 1 1/4” production range for mild steel Twice the speed of a 2000 on that thickness $17K to 2000 $12K power supply w/o THC $950 replacement cost Nozzle $36 Electrode $17 Swirl ring $36 Maintenance item Check o-rings for damage Check squareness to plate Look for heat damage Check breakaway for proper operation Point out that this is a water injected machine. Poorer cut quality on mild steel than dry plasma Allows high amperage cutting with N2 Generally considered a non-ferrous machine Maximum O2 amperage is 340A. 1 1/4” production range for mild steel Twice the speed of a 2000 on that thickness $17K to 2000 $12K power supply w/o THC $950 replacement cost Nozzle $36 Electrode $17 Swirl ring $36 Maintenance item Check o-rings for damage Check squareness to plate Look for heat damage Check breakaway for proper operation HPR130 System Overview Rev. 0 Copyright, 2004 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. * HPR130 System Overview Rev. 0 Copyright, 2004 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 系统安装 构成 电源 用铲车移动电源时确保铲起整个电源 放置电源的地方要求自然通风 要保持电源的前后完全通风. 不要安装其它的滤网，避免影响冷却。 构成 点火箱 点火箱必须安装在离电源45 m之内. 点火箱必须安装在离割枪15 m之内. 点火箱可以安装在电源内也可以安装在台架上. 构成 气体控制箱 气体控制箱必须安装在离电源45 m之内. 气体控制箱必须安装在离开关阀15 m之内. 气体控制箱仅可能的安装在离操作者近的地方. 气路系统 气源 如果使用普通的气源可以使用一个高质量的单调节阀，如果使用高压力的气体应该使用高质量的双调节阀. 调节器应该安装在离气体控制箱3 m之内 如果气管长度在23 m之内那内径应为9.5 mm.如果超过23 m 那么内径应为12.5 mm. 气路系统 气源压力 所有气体的初始压力应达到8 bar. 对保护气设定气体控制器到Test Pre-flow 然后调整到8 bar. 对等离子气设定气体控制器到Test Cut Flow然后调整到8 bar. 构成 开关阀总成 开关阀总成必须安装在离割枪1.2 m之内. 割枪 提升架必须离割枪51 mm之内. 割枪和提升装置在 “X” 和 “Y”轴上. 割枪的连接 Work lead (+) Electrode lead (-) Pilot arc lead (++) I