感应加热电源电路的设计.pdf

感应加热电源电路的设计 摘 要 本论文根据设计任务书的要求设计感应加热电源电路。首先介绍了感应加热技 术的原理与应用，并简单的分析了感应加热技术的现状和发展趋势。然后主要是对 感应加热电源电路进行理论上的设计，包括对整流电路、滤波电路、逆变电路的设 计,同时也包括对一些保护电路的设计和参数计算。 在本设计中，感应加热电源采用VMOSFET作为开关器件，可工作在100 kHz频率。 它由整流器、滤波器和逆变器三部分组成。由于输入侧是三相交流，整流电路采用 三相不可控全桥整流电路。为了提高可靠性和整机效率，采用PFC技术，即用LC滤 波。逆变器主要由PWM控制器UC3875控制四个VMOSFET的开通和关断，实现DC-AC的 转换。由于输出侧的电流小，电压大，为了能选到合适的快恢复整流二极管，采用 全桥整流电路，输出侧则采用LC滤波电路。 设计中采用的芯片主要是PWM控制器UC3875。设计过程中程充分利用了UC3875 的控制性能，具有宽的可调工作频率，死区时间可调，具有输入欠电压锁定功能和 双路输出电流。 关键词：感应加热，串联谐振，VMOSFET I 感应加热电源电路的设计 Abstract This paper is designed to mandate the requirements of the induction heating power circuit design. First of all, it introduced the principles and application of the induction heating technology, and simply analysis the induction heating technology of the status quo and development trends. And then gives the design of the induction heating power supply circuit in theory, including the design of the rectifier circuit, filter circuit, and the inverter circuit, but also including the design and components parameters of the protection circuit. In this design, induction heating power used VMOSFET as a switching device, can work in the 100 kHz frequency. It is composed three parts of rectifier, filters and inverter. Due to input side is a three-phase, so we use not controllable full-bridge rectifier circuit as three-phase rectifier circuit. In order to improve circuit reliability and efficiency, we use a PFC technology, which is LC filter. Inverter is mainly use the chip UC3875 to control of the opening of four VMOSFET on and off by the PWM controller, and carry off DC-AC conversion. As the output side of the small current, voltage, in order to be elected to the quick restoration of the right rectifier diodes, we have adopted full-bridge rectif