ML梅花形弹性联轴器选型参数表.pdf免费

ML梅花形弹性联轴器 ML p lum blossom ty pe elast ic shaft coupling 概述 梅花形弹性联轴器是由两个带凸爪形状相同的半联轴器和弹性元件组成，利用梅花形弹性元件置于两半联轴器凸爪牙之间， 以实现两半轴器的联接。具有补偿两轴相对偏移，减振，缓冲，径向尺寸小，结构简单，不用润滑，承载能力较高，维护方便 等特点，但更换弹性元件时两半联轴器需沿轴向移动。适用于联接两同轴线，起动频繁，正反转变化，中低速中小功率，传动 轴系，要求工作可靠性高的场合，不适用于重载及轴向尺寸受限制，更换弹性元件后两轴线对中困难的场合。 Plum blossom type elastic shaft coupling is made up of semi-shatf coupling with the same protruding claw and elastic component, utilizing the plum blossom elastic component put between the protruding claw and two half coupling. in order to realize the connection of two semi-axis devices. It has compensating by two axle to be relative skew, reducing shaking buffering. smaller diameter. simple structure, without lubricating. bearing large capacity, and convenient repair. But the semi-shaft coupling needs to move along the axial while changing the elastic component. It is suitable for two with axis, start frequent,.positive and negative change, low-speed and medium speed. Medium and small power rotate axle department, requiring working dependability high working position; it is not suitable for the heavily loaded and restricted axial in size. Two axis put in the difficult position after exchange of elastic component. 标记示例The mark gives a demonstration ML4型梅花形弹性联轴器 主动端：Z型轴孔，C型键槽，轴孔直径d1=35mm，轴孔长度L=62mm 从动端：Y型轴孔，B型键槽，轴孔直径d2=24mm，轴孔长度L=65mm ML Plum blossom type elastic shaft coupling Linitiative department: Z type shaft hole, C type dent key, shaft hole d1=35mm, Length of the shaft hole L=62mm Driven department: Y type shaft hole, B type dent key, shaft hole d2=24mm, Length of the shaft hole L=65mm 标记方法 ZC35 ×62 Y型轴孔 1:10 Z型轴孔 联轴器(Shaft coupling)ML4