外文翻译原文--小型PIC单片机与PC机模拟串行通信.pdfVIP

International Symposium on Test Automation and Instrumentation ISTAI’2008 Analog Serial Communication Between Minitype PIC and PC Liu Huachang (The Institute of Electronic Engineering of CAEP, Miangyang 621900, China) Abstract: The minitype PIC is widely used for PC serial level is that: logic “1” and “0” are 2.4V and 0.4V. communication anlog with the development of PIC. However, When the RS-232C bus is used for serial some minitype PIC haven’t inside serial interface, user need to communication, we need connect external circuit to design hardware and software for it. In this paper, the serial transform level. We should transform TTL/CMOS communication problem is solved by design of serial level to RS-232C level at the end of transmission, communication between minitpye PIC and PC based on transforming RS-232C level to TTL/ CMOS level at Labview. the end of receiver. MAX232 is usual drive chip for Keywords: PIC; Labview; serial communication serial transmit/receive. Moreover, its peripheral circuit is easy, which only need 4 capacitors whit 0.1uF. The 1 Introduction circuit is shown in figure 1. PIC series are a sort of microcontroller with new type CMOS technics, the PIC12FX is the mid-range series of PIC with 8 pins, which have characteristic with practicality \low price \saving power \ minitype \high speed etc.. So it fit to use in