某省道兴化至泰州段建设工程设计.docVIP

某省道兴化至泰州段建设工程设计 摘要：本设计为某省道兴化至泰州段建设工程设计，包括方案、路线、路基路面、排水系统以及沿线主要配套设施的设计。本工程设计速度为80km/h，本次设计包括道路平面设计, 道路纵断面设计, 道路横断面设计,路基设计，沥青路面设计，路基路面排水设计，桥涵及附属构造物设计等。 本设计的路线，纵断面设计共设3个边坡点，最大坡度为0.818％，最小坡度为0.33％。竖曲线半径分别有25000m，15000m，20000m（自己改）。路基宽度为26m，行车道宽度为3.75m，土路肩0.75m，硬路肩3m，中央分隔带3.5m。路面结构中，面层采用沥青混凝土（13cm），其中表面层采用细粒式密级配沥青混土（厚度3cm），中面层采用中粒式密级配沥青混凝土（厚度4cm），下面层采用粗粒式密级配沥青混凝土（厚度6cm）；基层采用石灰土（厚度为45cm）；底基层采用碎石灰土（厚度为25cm）。本路段设计桥涵2座桥，结合桥头地质情况综合考虑灌溉、排涝及地方出行的要求进行桥跨布置。 关键词:工程设计 纵断面 横断面 路基设计 沥青路面设计 桥涵及附属构造物设计 Abstract: The design, construction and engineering design, including the design of programs, routes, subgrade and pavement, drainage systems, as well as along the main supporting facilities of the province Road Xinghua, Taizhou segment. This engineering design speed of 80km / h, this design includes the road graphic design, road vertical alignment design, road cross-sectional design, the design of embankment, asphalt pavement design, subgrade and pavement drainage design, bridge and subsidiary structures design.?This design, too, Profile Design, 3 slope, the maximum gradient of 0.818%, the minimum slope of 0.33%. Vertical curve radius of 25000m, 15000m, 20000m (change). Roadbed width of 26m, the carriageway width of 3.75m, 0.75m soil shoulder hard shoulder 3m, the central median of 3.5m. Pavement structure, the surface layer of asphalt concrete (13cm), the surface layer is fine-grained type dense-graded asphalt mix soil (thickness 3cm) in the surface layer in grain-type dense-graded asphalt concrete (thickness 4cm), the following layer of coarse grain type dense-graded asphalt concrete (thickness 6cm); primary calcareous soil (thickness 45cm); sub-base gravel dust (thickness 25cm). The design of the sections of bridges and culverts 2 bridge, combined with the the bridgehead geological conditions considering the travel requirements of irrigation, drainage and local bridge span arrangement.Keywords: engineering design longitudinal cross-sectional roadbed