原创力文档- 1、本文档共18页，可阅读全部内容。
- 2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
- 3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
查看更多
课程设计报告
课程设计名称：
学 生 姓 名：
学 院：
专业及班级：
学 号：
指导教师：
年月日
目录
一、造型材料选择················································································1
二、铸造工艺参数设计···········································································1
1.加工余量的选择···············································································2
2.铸件孔是否铸出的确定········································································2
3.起模斜度的确定···············································································2
4.铸造圆角的确定···············································································3
5. 铸造收缩率的确定···········································································3
6.考虑加工余量后的尺寸········································································4
三、造型方法的设计··················································································4
1.环形型芯外形··················································································5
2.环形型芯尺寸··················································································5
3.中心孔木质芯盒造型···········································································6
4.1/4环形木质芯盒造型·········································································7
四、木模的设计·······················································································8
1.木模的外形设计················································································8
2.木模的设计尺寸················································································9
五、浇注系统和冒口设计·············································································10
1.浇注系统选择··················································································10.
2冒口的选择·····················································································10
六、铸型装配图设计·····················································································11
造型材料和铸造合金的选择
1. 造型材料~10%）来代替石英砂。在湿模造型时，小型和
文档评论（0）